Maple-systems Windows Embedded CE 6.0 Pro Edition Manuale Utente

Introduction Thank you for purchasing a Maple Systems OMI5000 Series Open HMI This booklet describes the steps necessary for installing the OMI5000 Se

1010-1017 Rev. 00 10 The OMI should be mounted into a panel with a depth of at least 4 in. (105 mm). Allow a clearance of at least 1 in. (25 mm) on

1010-1017 Rev. 00 11 STEPS: 1. Prepare the clamps for the OMI by inserting the screws into the clamp as shown above. Position the screws so that t

1010-1017 Rev. 00 12 Ethernet To connect your OMI to your computer via the10/100 Base-T Ethernet port requires a standard Ethernet crossover cable

1010-1017 Rev. 00 13 Fusing Requirements If the display does not come on within two seconds of power up, remove power. An internal fuse will preven

1010-1017 Rev. 00 14 COM1 [RS-485 2/4 W] Port, COM3[RS-485] Port Pin out of DE9S (female) connector Pin# COM1 [RS-485 2W] COM1 [RS-485 4W] COM3[RS

© 2012 Maple Systems Inc. All rights reserved. Maple Systems Inc. 808 134th Street SW, Suite 120 Everett, WA 98204-7333 Phone:

1010-1017 Rev. 00 2 Unpacking the Unit Carefully unpack the OMI. Please read any instructions or cautions that appear on the shipping container. Ch

1010-1017 Rev. 00 3 Maple Systems liability is limited to the repair or replacement of the Product only, and not costs of installation, removal, or

1010-1017 Rev. 00 4 Environmental Considerations The OMI5000 Series is designed to operate in temperatures from 0° to 50°C (32° to 122°F). It is i

1010-1017 Rev. 00 5 Figure 1: Typical Panel Layout Control Panel Grounding The control panel must be connected to a good, high-integrity earth gr

1010-1017 Rev. 00 6 Technical Note #1027, “OIT Ground Wiring and Electrical Noise Reduction,” which you can find in the Support Center Technical No

1010-1017 Rev. 00 7 and differential mode attenuation. In applications that may have high frequency noise present, we also recommend using a resist

1010-1017 Rev. 00 8 Installation It is necessary to follow all installation procedures described in this chapter for electrical noise immunity and

1010-1017 Rev. 00 9 To connect the OMI to power: 1. Connect the power cable to the OMI. a. Strip the power cable shield to expose 2” of the blac